(NATURAL STONE SEALER )
DESCRIPTION:
Stone Sealer is a siloxane penetrating sealer designed specifically for the treatment of Natural Stone surfaces. Sealer protects Natural Stone surfaces from the effects of exterior exposure and weathering. especially formulated sealer penetrates deep into the surface pores and reacts chemically to provide a durable, long lasting barrier against water and salt intrusion. This level of protection can substantially reduce the damaging effects of freeze/thaw cycling, precipitation, acid rain, efflorescence, and dust/dirt degradation.
PRIMARY APPLICATIONS:
- Natural stone
- Precast concrete
- Exposed aggregate
- Architectural concrete
- Ideal for use on paths, patios and block paving
FEATURES & BENIFITS
- Deep penetrating pore action for long lasting protection.
- Preserves a natural appearance without membrane build-up.
- Provides a highly efficient barrier to water and salt ingress.
- Allows natural stone surfaces to maintain breathability while providing high water repellency characteristics.
- Easy to use requiring only low pressure spraying equipment or applied by brush.
- Economical due its durability over many years..
PRODUCTS INFORMATION:
PACK SIZE: 1kg, 5kg & 20 kg Bucket
Appearance / Colour: Milky White liquid
Shelf Life: 12 months from date of manufacture in unopened containers.
Storage Conditions: Store upright in original, tightly sealed containers and in a dry cool well ventilated area. Protect from sunlight and frost.
Density: 1.0 g/cm3
pH-Value: 9.0
Volatile organic compound (VOC) content: 0.19%
Viscosity: Water thin
APPLICATION INFORMATION
CONSUMPTION ESTIMATE: Approx 80 Sq ft/litre (depending upon the porosity of the substrate)
INSTRUCTION FOR USER
- Shake well before use.
- Use Dr. Wall Care Stain remover to remove any Cements/ dirt spot from stones.
- Ensure the surface is clean, dry & free of any substance contaminants.
- Apply Dr. Wall care stone sealer using a soft brush, sponge, or sprayer.
- Leave it to soak for 10-20 minutes and wipe off any surplus sealer remaining on tile/stone surface.
- One Coat is sufficient for most application. In case of highly porous substrates, apply two or more coats. Allow approximately 1 hour of drying time between coats.
PRECAUTIONS:
Keep out of reach of children. Wear suitable protective clothing, gloves, and eyes/face protection. After contact with skin, wash immediately with plenty of clean water. In case of contact with eyes rinse immediately with plenty of clean water and seek medical advice